SCOM web application transaction monitor: error code 2147954430

The cause of an error code of 2147954430 from a web application transaction monitor can be difficult to determine, especially as it’s often intermittent. In my case, investigating the watcher node revealed that too many long-running calls had been included in the monitor and this had caused a backlog on the node, as described by event ID 10503 in the Operations Manager log:

The HTTP URL Monitoring Module detected that a backlog of processing has happened. It might be an indication of too many URL monitors configured for this watcher node.

The solution was to increase the interval between executions of the monitor to one that more realistically reflected the likely execution time. And it might be useful to create a rule to raise alerts from these events on the watcher nodes.

3 thoughts on “SCOM web application transaction monitor: error code 2147954430

  1. David Muzzy says:

    What did you do to increase the interval? As far as I can tell, there’s no override value for that. Did you edit the value in the MP itself?

    • Gary Pendlebury says:

      The interval can be increased in the Web Application Transaction Monitor template editor. Go to Authoring > Management Pack Templates > Web Application Transaction Monitoring, open your monitor, then select Configure Settings > Watcher Node.

      • David Muzzy says:

        Fantastic! Thank you so much for getting back to me so quickly, this is going to save me a lot of work. 🙂

Leave a Reply

Your e-mail address will not be published. Required fields are marked *